Back to Blog
Elk bledom camera7/14/2023 ![]() ![]() Version of the TLS protocol, the user must specify the TLS version to connect. Note that ELK-M1XEP does not support auto-negotiation of the When adding the ElkM1 integration in the user interface use secure for TLS 1.0 and In secure mode the version of the ELK-M1XEP determines which secure protocol is supported.ĮLK-M1XEP versions less than 2.0.46 support TLS 1.0, while version 2.0.46 and above support The ELK-M1XEP is the Ethernet controller board for the ElkM1. Check the “ElkM1 RS232 Protocol” manual for details. Many features will work with lower versions of the ElkM1. ElkM1 Versionįorce arm away and stay are available in 5.3.0 or higher. In order for the ElkM1 integration to work to its fullest with Home Assistant theĮlkM1 panel must be configured correctly. This document can be found on the Internet. ![]() The implementation follows the Elk Products ElkM1 “ASCII Protocol & Interface Switch - ElkM1 outputs are represented as switch entities.Sensor - ElkM1 counters, keypads, panel, settings, and zones are represented as sensor entities.Scene - ElkM1 tasks are represented as scene entities. ![]() Light - An ElkM1 light (which can be X10, Insteon, UPB) is represented as a light.Climate - An ElkM1 thermostat is represented as a climate entity.Normal is off and any of the other values is on. Binary Sensor - ElkM1 zones that have 4 states (i.e.: are not analog zones) are represented as binary_sensor entities.Alarm - An ElkM1 area (also known as partition) is represented as an alarm_control_panel.There is currently support for the following device types within Home Assistant: The Elk-M1 controller is manufactured by Elk Products. The Elk-M1 is a home security and automation controller that is capable of alarm control panel functions and automation. ![]()
0 Comments
Read More
Leave a Reply. |